Influence of calibration methodology on ground water flow predictions

We constructed a numerical model of transient ground water flow and solute transport for a portion of the Biscayne Aquifer in Florida, and calibrated the model with three different combinations of data from a 193-day period: head (h) data alone, data on h and ground water discharge to a canal (q), and data on h, q, and ground water chloride concentration (C). We used each of the three calibrated models to predict h and q during a 182-day test period separate from the calibration period. All three calibrated models predicted h equally well during the test period (r = 0.95, where r = 1 indicates perfect agreement between measured and simulated values), though the model calibrated on h alone had significantly different parameter values than the other two models. Predictions of q during the test period depended on calibration methodology; models calibrated with multiple targets simulated q more accurately than the model calibrated on h alone (r = 0.79 compared to r = 0.49). Based on the results of these simulations, we conclude: (1) Post-calibration prediction is important in assessing the value of different data types in automated calibration; (2) inverse-solution uniqueness is not a requirement for accurate h predictions; (3) relatively simple models can predict with reasonable accuracy transient ground water flow in a complex aquifer, and parameters governing this prediction can be estimated by nonlinear regression methods that incorporate both h and q data; (4) addition of C data to the calibration did not improve model predictive capacity because the information in the C data was similar to that in the q data, from the perspective of model calibration (the subsurface chemical signal in question was controlled mainly by seepage of high-chloride canal water into the low-chloride ground water system).     

Relict silicate inclusions in extraterrestrial chromite and their use in the classification of fossil chondritic material

Chromite is the only common meteoritic mineral surviving long-term exposure on Earth, however, the present study of relict chromite from numerous Ordovician (470 Ma) fossil meteorites and micrometeorites from Sweden, reveals that when encapsulated in chromite, other minerals can survive for hundreds of millions of years maintaining their primary composition. The most common minerals identified, in the form of small (<1-10 μm) anhedral inclusions, are olivine and pyroxene. In addition, sporadic merrillite and plagioclase were found.Analyses of recent meteorites, holding both inclusions in chromite and corresponding matrix minerals, show that for olivine and pyroxene inclusions, sub-solidus re-equilibration between inclusion and host chromite during entrapment has led to an increase in chromium in the former. In the case of olivine, the re-equilibration has also affected the fayalite (Fa) content, lowering it with an average of 14% in inclusions. For Ca-poor pyroxene the ferrosilite (Fs) content is more or less identical in inclusions and matrix. By these studies an analogue to the commonly applied classification system for ordinary chondritic matrix, based on Fa in olivine and Fs in Ca-poor pyroxene, can be established also for inclusions in chromite. All olivine and Ca-poor pyroxene inclusions (>1.5 μm) in chromite from the Ordovician fossil chondritic material plot within the L-chondrite field, which is in accordance with previous classifications. The concordance in classification together with the fact that inclusions are relatively common makes them an accurate and useful tool in the classification of extraterrestrial material that lacks matrix silicates, such as fossil meteorites and sediment-dispersed chromite grains originating primarily from decomposed micrometeorites but also from larger impacts.     

Fluid flow and pore pressure development throughout the evolution of a trough mouth fan,western Barents Sea

Using a combination of geophysical and geotechnical data from Storfjorden Trough Mouth Fan off southern Svalbard, we investigate the hydrogeology of the continental margin and how this is affected by Quaternary glacial advances and retreats over the continental shelf. The geotechnical results show that plumites, deposited during the deglaciation, have high porosities, permeabilities and compressibilities with respect to glacigenic debris flows and tills. These results together with margin stratigraphic models obtained from seismic reflection data were used as input for numerical finite element models to understand focusing of interstitial fluids on glaciated continental margins. The modelled evolution of the Storfjorden TMF shows that tills formed on the shelf following the onset of glacial sedimentation (ca. 1.5 Ma) acted as aquitards and therefore played a significant role in decreasing the vertical fluid flow towards the sea floor and diverting it towards the slope. The model shows that high overpressure ratios (up to λ ca. 0.6) developed below the shelf edge and on the middle slope. A more detailed model for the last 220 kyrs accounting for ice loading during glacial maxima shows that the formation of these aquitards on the shelf focused fluid flow towards the most permeable plumite sediments on the slope. The less permeable glacigenic debris flows that were deposited during glacial maxima on the slope hinder fluid evacuation from plumites allowing high overpressure ratios (up to λ ca. 0.7) to develop in the shallowest plumite layers. These high overpressures likely persist to the Present and are a critical precondition for submarine slope failure.     

Glacial and environmental changes over the last 60 000 years in the Polar Ural Mountains,Arctic Russia,inferred from a high‐resolution lake record and other observations from adjacent areas

Our knowledge about the glaciation history in the Russian Arctic has to a large extent been based on geomorphological mapping supplemented by studies of short stratigraphical sequences found in exposed sections. Here we present new geochronological data from the Polar Ural Mountains along with a high‐resolution sediment record from Bolshoye Shchuchye, the largest and deepest lake in the mountain range. Seismic profiles show that the lake contains a 160‐m‐thick sequence of unconsolidated lacustrine sediments. A well‐dated 24‐m‐long core from the southern end of the lake spans the last 24 cal. ka. From downward extrapolation of sedimentation rates we estimate that sedimentation started about 50–60 ka ago, most likely just after a large glacier had eroded older sediments from the basin. Terrestrial cosmogenic nuclide (TCN) exposure dating (¹⁰Be) of boulders and Optically Stimulated Luminescence (OSL) dating of sediments indicate that this part of the Ural Mountains was last covered by a coherent ice‐field complex during Marine Isotope Stage (MIS) 4. A regrowth of the glaciers took place during a late stage of MIS 3, but the central valleys remained ice free until the present. The presence of small‐ and medium‐sized glaciers during MIS 2 is reflected by a sequence of glacial varves and a high sedimentation rate in the lake basin and likewise from ¹⁰Be dating of glacial boulders. The maximum extent of the mountain glaciers during MIS 2 was attained prior to 24 cal. ka BP. Some small present‐day glaciers, which are now disappearing completely due to climate warming, were only slightly larger during the Last Glacial Maximum (LGM) as compared to AD 1953. A marked decrease in sedimentation rate around 18–17 cal. ka BP indicates that the glaciers then became smaller and probably disappeared altogether around 15–14 cal. ka BP.     

A Mariner 9 atlas of the moons of Mars

This paper contains a complete set of the best enhancements of Mariner 9 high resolution television pictures of Phobos and Deimos, consisting of 27 different views of Phobos, and 9 of Deimos. Pertinent data about the pictures are arranged in convenient tabular and graphical form.     

Flüssigkeitseinschlüsse mit Gasblasen als geologische Thermometer

Zusammenfassung Es wird unterschieden zwischen Einschlüssen, auf dieSorbys Grundannahme zutrifft, daß eine homogene Phase, wie Wasser, Salzlösung oder CO₂, eingeschlossen wurde, die Blasen also von dem Gas der eingeschlossenen Flüssigkeit gebildet werden, und solchen Einschlüssen, in denen fremdes Gas mit eingeschlossen wurde.Sorby-Einschlüsse können zur Temperaturbestimmung herangezogen werden, wenn entweder der Druck am Bildungsort bekannt ist oder sein Einfluß vernachlässigt werden kann, weil der Füllungsgrad so hoch ist, daß die Libelle schon bei niederen Temperaturen verschwindet. Ist fremdes Gas in der Flüssigkeit gelöst eingeschlossen worden und erst beim Abkühlen frei geworden, so ist der Schluß von der Füllungstemperatur auf die Bildungstemperatur noch unsicherer als bei Sorby-Einschlüssen, weil über den zu erwartenden großen Einfluß des Druckes noch nichts bekannt ist.Ist fremdes Gas als Gasblase eingeschlossen worden, so kann die Füllungstemperatur sehr weit von der Bildungstemperatur abweichen und beim Erwärmen sogar zuerst größer werden. Solche Nicht-Sorby-Einschlüsse sind zu erkennen durch Messung des Füllungsgrades und Vergleich der zugehörigen Füllungstemperatur mit der von Wasser bzw. CO₂ bei gleichem Füllungsgrad.Die Frage, aus was die Einschlüsse bestehen, ist nicht nur für die Temperaturbestimmung von Wert, sondern auch für viele Fragen der Gesteinsbildung und -umbildung. Es wird auf die schon vonBrewster 1826 angegebene Methode der Bestimmung der Brechungszahl mit Hilfe der Totalreflexion hingewiesen.Alle diese Bemerkungen gelten sowohl für primäre wie für sekundäre Einschlüsse.Die Dekrepitationsmethode kann weder primäre und sekundäre Einschlüsse unterscheiden noch die Natur des Einschlusses, noch auch den Füllungsgrad berücksichtigen.     

Die Entwickelung und das Auftreten des Paläozoikums in Griechenland

Ohne Zusammenfassung